Securing The Child; Is Your Child Properly Secured - CUBEX JUNO-FIX Manual Del Usario

n
f
n
17
r
l
m

SECURING THE CHILD

• Put the child in the child seat.
• Put the previously adjusted safety cushion (p) in place (see section
„aDJUSTinG THe SafeTy CUSHion")
• Draw out the three-point automatic belt to its fullest extent. Take the lap belt (n)
and insert it into the belt routing marked in red (r) of the safety cushion (p).
!
warning! Do not twist the belt!
• Push the belt tongue (m) into the belt buckle (l). This must lock into place with
an audible „CliCk".
• Pre-tension the lap belt (n) by pulling on the shoulder belt (f).
• now guide the shoulder belt (f) back through the belt routing (r) of the safety
cushion (p).
• Pull the shoulder belt (f) taut, taking care that both parts of the belt run over
the total width of the safety cushion (p), within the belt routing (r).

IS YOUR CHILD PROPERLY SECURED?

To guarantee the maximum safety for your child, please test the following before
departure:
• the safety cushion (p) is correctly adjusted.
• the belt tongue (m) has locked into place in the belt buckle (l).
• the lap belt (n) and the shoulder belt (f) are running taut through the belt
routing of the safety cushion (p) and are not twisted.
• the seat cushion (d), when iSofix Connect is used, has locked into place on
both sides with the connectors (w) into the iSofix anchorage points (i) and
both green safety indications (x) can be seen clearly.
• the backrest (a) of the child seat lies completely flush with the backrest of the
car seat. (exception see section, „SiTTinG anD ReClininG PoSiTion").