Electrical Connection - Nibe MSR 60 Instrucciones De Instalación

Electrical connection

-E97B
-E97A
6
1
NOTE
All electrical connections must be carried out by an
authorised electrician.
Electrical installation and wiring must be carried out
in accordance with the stipulations in force.
The electrical circuit diagram is at the end of these installation
instructions.
1. Fasten the two DIN rails under soft start positions -E97A
and-E97B with the four supplied M5 torx screws. See il-
lustration.
2. Connect the cables 0301, 0303 and 0305 from cable kit
to filter -Z60A "Load out".
- Brown cable 0301 is connected to L1
- Brown cable 0303 is connected to L2
- Grey cable 0305 is connected to L3
1
2
-Z60B
-Z60A
5
4
-K68A
-K68B
K68A/B
13NO
2 5
L1 L2 L3
A1
A2
4 6
T1 T2 T3
14NO
3. Connect the cables 0310, 0312 and 0314 from cable kit
to filter -Z60B "Load out".
- Brown cable 0310 is connected to L1
- Brown cable 0312 is connected to L2
- Grey cable 0314 is connected to L3
4. Disconnect existing cables(015, 016, 018, 064) from
-K68A and connect them to -Z60A "Line in".
- Brown cable 015 is connected to L1
- Brown cable 016 is connected to L2
- Grey cable 018 is connected to L3
- Blue cable 064 is connected to N
Now screw -Z60A into place with the supplied M4 torx
screws according to the image.
5. Disconnect existing cables(020, 021, 022, 065) from
-K68B and connect them to -Z60B "Line in".
- Brown cable 020 is connected to L1
- Brown cable 021 is connected to L2
- Grey cable 022 is connected to L3
- Blue cable 065 is connected to N
Now screw -Z60B into place with the supplied M4 torx
screws according to the image.
6. Install soft start -E97A and -E97B on relevant DIN rail.
7. Soft start -E97A and -E97B must connected in parallel
with -K68A and -K68B.
E97A/B
L1 L2
A1 A2
0,4
RAMP UP
0,1
0,4
RAMP DOWN
0
25
INT.TORQUE
0
P1 P2 11 21 22
T1 T2
MSR 60
L3
0,7
1,0 sec
0,7
1,0 sec
50
70 %
T3
GB
7