Airone ZAIRA INOX 90 Manual De Instrucciones Para El Uso, Mantenimiento E Instalación página 16

The hood is supplied with a side hinged cover support. The cover is available in steel (supplied with the stainless steel
downdraft models), in glass (supplied with the glass downdraft models) or in the same material used for the kitchen
tops (not supplied, MAX 7Kg).
The gluing of the cover of the downdraft, must be performed in the same place after finishing the assembly of the
downdraft. The space between the lid and hole on the top should be about 1.5mm long the whole perimeter.
The model and technical data labels can be attached to the cover on the downdraft unit and behind the metal filters.
Caution: In the kitchen furniture, provide in front or behind of the downdraft a removable wall to allow technicians to
remove the front or rear panel of the hood in case of assistance. The assistance must be performed by authorized
specialists. Failure to comply with this condition, significant increased costs could be charged in the case of
assistance.
It is possible to connect on the front or on the back part of the downdraft a tube of diameter 150 or 200mm
according to the suction motor used. Remove the lid traced out before with the help of a hammer and fix the flange
with 4 screws already included. Then connect the tube.
ZAIRA +AMR+AME+AMD
D
EN -13