Sewing Basics; Please Read Before Sewing; Starting Sewing - Brother 885-X01 Manual De Instrucciones

SEWING BASICS — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
2

SEWING BASICS

Please read before sewing

CAUTION
●
To avoid being injured, watch the needle
carefully while you are using the
machine. Keep your hands away from
moving parts.
●
Do not stretch or pull the fabric during
sewing, otherwise the needle may be
damaged and you may be injured.
●
Do not use bent or broken needles,
otherwise you may be injured.
●
Take care that the needle does not hit
basting pins or other objects during
sewing. The needle may break and you
may be injured.
●
Always use the correct presser foot. If
you use the wrong presser foot, the
needle may hit the presser foot and bend
or break and you may be injured.
●
When you turn the handwheel by hand,
always turn it toward you
(counterclockwise). Turning it the other
way may cause the thread to tangle and
damage the needle or fabric, and you
may be injured.
●
Do not start sewing without placing the
fabric under the presser foot, otherwise
the presser foot may be damaged.

Starting sewing

Turn on the machine.
1
CAUTION
●
Do not turn on the machine while
pressing down the foot controller. The
machine may start unexpectedly and
cause personal injury or damage to the
machine.
17
Raise the needle by turning the
2
handwheel toward you
(counterclockwise) so that the mark on
the wheel points up.
Turn the pattern selection dial to select a
3
stitch (see page 9).
Change the presser foot (see page 8).
4
Raise the presser foot lever.
5
1 Presser foot lever
Place the fabric under the presser foot,
6
pass the thread under the presser foot,
and then pull out about 5 cm (2 inches) of
thread toward the rear of the machine.
1
1 5 cm (2 inches)
While holding the end of the thread and
7
the fabric with your left hand, turn the
handwheel toward you
(counterclockwise) with your right hand
to lower the needle to the starting point of
the stitching.
Lower the presser foot lever.
8
1 Presser foot lever
1
1