Klarstein 10031434 Manual Del Usaurio página 34

Sleep 2 is sleep mode 2, that is air conditioner will run according to the presetting a group
of sleep temperature curve.
Sleep 3- the sleep curve setting under Sleep mode by DIY:
(1) Under Sleep 3 mode, press „Turbo" button for a long time, remote control enters into
user individuation sleep setting status, at this time, the time of remote control will display
„1 hour", the setting temperature „88" will display the corresponding temperature of last
setting sleep curve and blink (The first entering will display according to the initial curve
setting value of original factory);
(2) Adjust „+" and „-" button, could change the corresponding setting temperature, after
adjusted, press „Trubo „button for confirmation;
(3) At this time, 1 hour will be automatically increased at the timer postion on the remote
control, (that are „2 hours „ or „3 hours „ or „8 hours „), the place of setting temperature
9 SLEEP
„88" will display the corresponding temperature of last setting sleep curve and blink;
(4) Repeat the above step (2) (3) operation, until 8 hours temperature setting finished,
sleep curve setting finished, at this time, the remote control will resume the original timer
display; temperature display will resume to original setting temperature.
Sleep3 - the sleep curve setting under SLEEP mode by DIY could be inquired: The user
could accord to sleep curve setting method to inquire the presetting sleep curve, enter
into user individuation sleep setting status, but do not change the temperature, press „Tur-
bo" button directly for confirmation. Note: In the above presetting or enquiry procedure,
if continuously within10s, there is no button pressed, the sleep curve setting within10s,
there is no button pressed, the sleep curve setting status will be automatically quit and re-
sume to display the original displaying. In the presetting or enquiry procedure, press „ON/
OFF" button, „Mode" button, „Timer"button or „Sleep" button, the sleep curve setting or
enquiry status will quit similarly.
Press this button, could select displaying the indoor setting temperature or indoor ambient
temperature.When the indoor unit firstly power on it will display the setting temperature, if
the temperature's displaying status is changed from other status to [ ] displays the ambi-
10 TEMP
ent temperature, 5s later or within 5s, it receives other remote control signal that will return
to display the setting temperature. if the users haven't set up the temperature displaying
status,that will display the setting temperature.
Press this button, the Quiet status is under the Auto Quiet mode (display [ ] and [Auto])
aand Quiet mode (display [ ]) and Quiet OFF (there is no signal displayed), after powered
11 QUIET
on, the Quiet OFF is defaulted. Note: the Quiet function cannot be set up in Fan and Dry
mode; Under the Quiet mode, the fan speed is not available.
Press CLOCK button, blinking [ ]. Within 5 seconds,pressing + or - button adjusts the pre-
sent time. Holding down either button above 2 seconds increases or decreases the time
12 CLOCK by 1 minute every 0.5 second and then by 10 minutes every 0.5 second. During blinking
after setting, press CLOCK button again to confirm the setting, and then the symbol will
be constantly displayed.
34