Using The Device For The First Time; Assembling The Device - Microlife BC200 Comfy Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 10
 Do not use any abrasives or anti-bacterial cleaning agents.
 Sterilise all parts that come into contact with the breast milk for
five minutes in boiling water.
 Clean the device before each use.
 Make sure that the temperature of the liquid in the bottle never
exceeds 50 °C.
Ensure that children do not use this device unsupervised;
some parts are small enough to be swallowed. Be aware of
the risk of strangulation in case this device is supplied with
cables or tubes.
IMPORTANT
When transporting breast milk in the bottle (e.g. when on
the move or travelling), make sure that the bottle cap is
always screwed on tightly.
WARNING
Notes on handling batteries
 If your skin or eyes come into contact with battery fluid, rinse the
affected areas with water and seek medical assistance.
 Choking hazard! Small children may swallow and choke on
batteries. Store the batteries out of the reach of small children.
 Observe the plus (+) and minus (-) polarity signs.
 If a battery has leaked, put on protective gloves and clean the
battery compartment with a dry cloth.
 Protect batteries from excessive heat.
 Risk of explosion! Never throw batteries into a fire.
 Do not charge or short-circuit batteries.
 Use identical or equivalent battery types only.
 Always replace all batteries at the same time.
 Do not use rechargeable batteries.
 Do not disassemble, split or crush the batteries.
Remove batteries if the device is not going to be used for a
prolonged period.
Disposal
Batteries and electronic devices must be disposed of in
accordance with the locally applicable regulations, not with
domestic waste.
BC 200 Comfy

3. Using the Device for the First Time

NOTE:
Check that the packaging of the device has not been
tampered with and make sure that all components are
present. Before use, ensure that there is no visible damage
to the device or accessories and that all packaging material
has been removed. If you have any doubts, do not use the
device and contact your retailer or the specified Customer
Services address.

Assembling the device

Once the device has been removed from the packaging, check the
plastic containers in particular for cracks.
1. Screw the pump attachment 8 onto the bottle AT. Ensure the
pump attachment is firmly secured so that no liquid can escape
(see short instruction).
2. Insert the silicone tube 7 into the pump attachment and the
device.
3. Connect the device to the mains cable and insert the mains plug
into the socket.
4. If you choose to operate the device using batteries, open the
battery compartment cover on the rear side of the motor unit.
Insert the batteries (4 x 1.5 V, size AA), observing the indicated
polarity. Close the battery compartment until you hear and feel
it click into place. A single battery charge with 4 x 1.5 V new AA
batteries will last for approximately 60 minutes of operation (at
the lowest setting).
Cleaning and sterilising the device
WARNING
Clean and sterilise the separate parts of the device that
come into direct contact with the breast milk individually
before first use and any further use.
To sterilise the device correctly, proceed as follows:
1. Unscrew the pump attachment 8 from the bottle AT.
2. Remove the silicone tube 7 from the pump attachment 8 and
from the device.
3. Separate the pump attachment from silicone membrane and
silicone valve.
4. Sterilise the bottle and pump attachment (with silicone
membrane and silicone valve) for five minutes in boiling water
or using a steam steriliser. Do not use the device until all indi-
EN
5

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido