Gallagher M50 Instrucciones página 10

5-Step Installa on Guide
Step 3. How to install the fence
1. Plan the fence line. Avoid rough, stony or steep areas if possible. For best
electric fence performance use mul -wire (at least 3 wires connected in
parallel) fencing.
2. Run out the bo om wire between the end posts.
3. Tension wires un l there is only a slight visible sag.
4. Connect all live wires in parallel at the end of each fence sec on using Joint
Clamps G6030.
5. Connect the fence system under gateways, rather than overhead. Do not use
electric gates to get power across gateways. Install Lead-out Cable G6270
in a plas c pipe (for physical protec on), 30cm (12") deep. Turn the ends of
the pipe down to keep water out. Connect each end of the cable to the Joint
Clamps.
Cut-out switch
6. When joining wires under tension, use a fi gure eight or reef knot.
Off set Fence
Exis ng non-electric fences can be protected to last for many more years simply
by a aching off set brackets and an electrifi ed wire on one or both sides of the
non-electric fence. Use a single off set wire, posi oned at two thirds the height of the
animal (chest height) to be controlled.
10
Gallagher 3E1802 Small Mains Energizer User Manual
All-live wire system
Live cable
300mm (12") deep
Figure Eight
Joint clamps
Live
Live
Live
Reef Knot