Electrolux EWC 1050 Manual De Instrucciones página 8

8 electrolux
By selecting this option the water of the last
rinse is not emptied out to prevent the fab-
rics from creasing. When the programme
has finished, the lights "End" and "Door
locked" are lit to indicate that the water
must be emptied out (See: " At the end of
the programme").
No spin
By selecting this option all the spinning
phases are excluded. To be used for ex-
tremely delicate material. The machine will
add some additional rinses to the cotton
and synthetic programmes.
For the maximum spin speed allowed by
each programme, refer to the chapter
Washing programmes.
Select the Delay Start by pressing
button 2
Before you start the programme, if you wish
to delay the start, press the button 2 re-
peatedly, to select the desired delay. The
corresponding pilot light will light up.
You must select this option after you have
set the programme and before you press
button 6.
You can cancel or modify the delay time at
any moment, before you press button 6.
Cancelling the delayed start after having
pressed button 6:
1. Set the washing machine to PAUSE by
pressing button 6.
2. Press the button 2 once, the light rele-
vant to the selected delay goes off.
3. Press button 6 again to start the pro-
gramme.
Important! The selected delay can be
changed only after selecting the washing
programme again.
The door will be locked throughout the de-
lay time (door locked light lit).
The Delay Start can not be selected with
DRAIN or SPIN programme.
Select the desired option by means of
buttons 3, 4 and 5
Depending on the programme, different
functions can be combined. These must be
selected after choosing the desired pro-
gramme and before pressing the button
6.The relevant light will illuminate.
If an incorrect option is selected, the corre-
sponding indicator lamp flashes for about 2
seconds. For the compatibility of the op-
tions with the washing programmes, refer
to the chapter «Washing programmes».
Start the programme by pressing
button 6
To start the selected programme, press this
button; the corresponding pilot light stops
flashing and remains lit.
On programme progress display the pilot
lights A and E illuminate to indicate that the
appliance starts operating and the door is
locked.
Altering an option or a running
programme
It is possible to change any option before
the programme carries it out.
Before you make any change, you must
pause the washing machine by pressing the
button 6.
The programme can be changed as long as
the button 6 has not been pressed. Chang-
ing a running programme is possible only
by resetting it. Turn the programme selector
dial to and then to the new programme
position. Start the new programme by
pressing the button 6 again.
Interrupting a programme
Press the button 6 to interrupt a pro-
gramme which is running, the correspond-
ing light starts to flash. Press the button
again to restart the programme.