Pre-Installation; Assessing The Installation Location; Testing The Refrigerator; Preparing The Front Fan Location - Dometic CCF-T Manual De Instalacion Y Uso

CCF-T Refrigerator

6 Pre-Installation


WARNING: CARBON MONOXIDE AND/
OR VEHICLE SAFETY . Failure to obey the
following warnings could result in death or
serious injury:
• Park the vehicle in a well-ventilated area during the
installation process.
• Ensure the vehicle is in Park with the emergency
brake engaged at all times during the installation
process.
NOTICE: Avoid pinching, crushing, or breaking
the wires or power cord. Otherwise damage to the
refrigerator could occur.
This section describes the assessment and location
preparations to install the refrigerator.
6 .1 Assessing the Installation
Location
1. Confirm your vehicle is the correct model, model
year, and trim level to accept the refrigerator. See
"Specifications" on page 5 for more information.
Only trim packages with an integrated center floor
console are eligible.
2. Verify you have the correct parts and tools to perform
the refrigerator installation. See "Tools and Materials"
on page 4 for more information.

6 .2 Testing the Refrigerator

1. Open the console lid and remove all items stored in
the console bin, including the original trim tray and
the console floor liner.
The console lid should remain open during the pre-
I
installation and installation procedures.
2. Place the refrigerator unit in an upright position on a
stable surface next to the console.
3. Insert the refrigerator unit's 12 VDC power cord plug
into the vehicle's 12 VDC power receptacle.
4. Start the vehicle engine.
EN
5. Confirm the blue LED is illuminated on the
refrigerator unit's ON/OFF button. If not, press and
hold the button for one second, and then release.
6. Listen for the condenser fan to start. See
"Troubleshooting" on page 13 if the condenser
fan does not start.
7. Turn the vehicle engine OFF.
8. Press and hold the ON/OFF button to turn the
refrigerator unit OFF.
9. Unplug the 12 VDC power cord.
10. Set the refrigerator unit away from the console.

6 .3 Preparing the Front Fan Location

w
5 Using the Front Fan Template
2.4 in. (60 mm)
q
6.2 in. (158 mm)
w
1. Tape the front fan template to the inside, front wall of
the console bin.
2. Using a pen, trace the center point opening from the
template onto the console bin wall.
Pre-Installation
q
e
2.6 in. (67 mm)
e
7