Control Elements Torch Handle; Two-Cycle Trigger Function; Putting Out Of Operation - Abicor Binzel RB Serie Instructivo De Servicio

5 Control elements torch handle

5 Control elements torch handle
NOTICE
• The MAG welding torch must only be operated by qualified personnel (in Germany, see
TRBS 1203).
• Please also consult the operating instructions for the welding components, welding power
source and welding torch.
Using a standard welding torch, the two-position mode of the trigger can be activated.

5.1 Two-cycle trigger function

1 Press and hold the trigger on the handle = start welding.
2 Release the trigger = stop welding.
6 Operation
1 Open the shielding gas cylinder.
2 Switch on the power source.
3 Set the welding parameters.
4 Start welding.

7 Putting out of operation

NOTICE
• When putting the system out of operation, ensure that the procedures for switching off
each of the welding system components are observed.
• As liquid-cooled cable assemblies start to leak when they overheat, the coolant
recirculator should continue running for approx. 5 min. after welding.
1 Wait until the shielding gas post-flow time has passed.
2 Close the shut-off-valve for the gas supply.
3 Switch off the power source.
4 Close the valve of the shielding gas cylinder.
EN - 10
MAG Welding torches
BAL.0147 • 2018-11-09