Putting Into Operation; Setting Up The Torch Body - Abicor Binzel ABIPLAS WELD 100 POWDER W Instructivo De Servicio

®
ABIPLAS WELD 100/150 POWDER W

6 Putting into operation

6.1 Setting up the torch body

arc burns between the tungsten electrode and the anodically poled workpiece.
The plasma gas is expelled from the plasma nozzle's opening as a high-energy
plasma jet and provides the thermal energy required for welding. The filler
material is fed to the process in powder form. The arc and the molten pool are
protected by the inert gas or the active gas components. The cable assembly
serves as a supply line and is equipped with all connection elements.
DANGER
Risk of injury due to unexpected start-up
The following instructions must be adhered to throughout all maintenance,
servicing, assembly, disassembly and repair work:
• Switch off the power source.
• Close the gas supply.
• Disconnect the mains plug.
NOTICE
• The system may only be put into operation by qualified personnel (in
Germany see TRBS 1203).
This section provides all the information that must be taken into account when
putting the device into operation.
NOTICE
• The poor current and heat transfer of loosely fitted plasma nozzles will
result in irreparable damage to the torch.
6 Putting into operation
EN - 13