Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Maintenance Instructions
All maintenance operations are to be carried out as described in maintenance table. Their
frequency is given for your information, for pumps operating with fuel or oil in accordance with
specifi cations given in this manual.
If pump is used under extreme conditions, reduce interval between maintenance operations.
Maintenance Schedule
After fi rst 50 Hours of operation
● Change oil and fi lter.
Every 250 Hours
1
● Change oil and fi lter.
● Clean or replace air cleaner.
● Clean pump.
Every 500 Hours or Annually
● Replace fuel fi lter (E).
● Clean fuel tank.
● Clean spark arrester.
Every 500 Hours
2
● Set and clean injectors.
● Have valve lash checked/adjusted.
Perform these procedures more frequently under severe, dusty, dirty conditions.
1
Have a Kohler portable dealer perform this service.
2
Oil Recommendations
We recommend use of Kohler oils for best
performance. Other high-quality detergent
oils (including synthetic) of API (American
Petroleum Institute) service class CH-4 or
higher are acceptable. Select viscosity based
on air temperature at time of operation as
shown in table below.
°F -20
5
23
°C -30
-15
-5
* Synthetic base oil.
Check Oil Level
Ensure engine oil level is between upper and
lower limit of dipstick (R). Add oil as necessary.
1. Remove dipstick (R) and wipe it.
2. Put back dipstick (R) then take it out again.
Visually check level, it must be between
upper limit of dipstick (R) & lower limit of
dipstick (R).
3. Fill if necessary using a funnel.
4. Put dipstick (R) back in place.
5. Check that there are no leaks.
6. Wipe off excess oil with a clean cloth.
6
1
15W-40
SAE 30
5W-30*
32
40
50
60
80
0
10
20
30 35
Change Oil and Filter
NOTE: Drain engine oil into an approved
NOTE: If necessary, a second oil drain plug (T)
Change oil while engine is warm.
1. Clean area around oil fi ll cap (C). Remove oil
drain plug (T) and oil fi ll cap (C). Allow oil to
drain completely.
2. Reinstall oil drain plug (T).
3. With a hex key, remove oil fi lter holder
screws (U). Remove oil fi lter and discard it.
4. Clean oil fi lter holder and apply clean engine
oil onto oil fi lter joint.
95 100
40
5. Install new oil fi lter. Thread oil fi lter holder
screws (U) into oil fi lter holder and tighten.
6. Fill crankcase with new oil. Level should be
at top of indicator on dipstick (R).
7. Reinstall oil fi ll cap (C) and tighten securely.
8. Start engine; check for oil leaks. Stop engine;
correct leaks. Recheck oil level.
9. Dispose of used oil in accordance with local
ordinances.
KohlerPower.com
container. Never drain or spill engine
oil onto fl oor.
is available on other side of engine.
39 590 01 Rev. A
Publicidad
Tabla de contenido
