Assigning Zones - Moehlenhoff AR 4070SF2 N Manual De Instrucciones

Assigning zones

Supply operation voltage to the Wireless Basis if this has not already been
performed. After that, the assignment „Zone – Wireless Thermostat" can be
performed. The assignment should be done from the installation place of the
thermostat.
After the activation of learning mode at the Wireless base, (see Wireless base
manual), the desired heating zone can be assigned by pressing the SET button at
the thermostat. A log-on code will be sent to the base then.
You can find the complete instructions for the assignment „Wireless Thermostat
D
- zone" in the Wireless Basis AB 4071 manual.
GB
F
IT
ESP
NL
RUS
22