Natursoft Media Soak; Natursoft Media Flush - Enviro NaturSoft Pro Serie Manual Del Proprietário

Enviro Water Products Pro Series Water Filter and
Salt-Free NaturSoft System
®

NaturSoft Media Soak

Wall
Incoming
Water
Supply
Figure 9
CAUTION:
The Enviro Water Products Whole House Water Filter MUST be in the bypass position during this process
(see figure above).
1. Open a cold water faucet or test spigot close to the downstream of the Water Conditioner.
2. Turn the water back on at the main shut-off valve allowing the system to fill with water. The air
being displaced will escape through the open fixture downstream.
3. Turn the arrows on the Bypass Valve into the Bypass Mode position displayed above to bypass the
tank. This will allow you to isolate the system and restore water supply to the home/building
during the media soak.
4. Allow the tank to soak for at least 60 minutes.

NaturSoft Media Flush

CAUTION:
The Enviro Water Products Whole House Water Filter MUST be in the bypass position during this process
(see figure above).
1. After the tank has soaked for 60 minutes, turn the main water supply back on or turn the arrows
on the Bypass Valve back into their original position.
2. Flush the system by running water for 5 minutes at a high flow rate of 5 GPM (this can be
achieved by using a bath tub or more than 3 faucets).
Note: The flush water may have a milky look to it. This is normal as calcium carbonate fines are
flushed from the system.
3. Rinse the system by reducing the flow rate to ½ GPM and run water for 60 minutes (this can be
achieved by turning one faucet ¼ of the way on).
4. Turn the Whole House Water Filter Bypass Valve to the on position (out of Bypass Mode).
© 2014 Enviro Water Solutions LLC
3060 Performance Circle, Suite 2. DeLand, FL 32724
Bypass Mode
Whole House
Water Filter
Wall
Outgoing
Water to
House
Salt-Free NaturSoft
®
www.envirowaterproducts.com
Rev C
Page 14