Carbon Tank Flush - Enviro NaturSoft Pro Serie Manual Del Proprietário

Enviro Water Products Pro Series Water Filter and
Salt-Free NaturSoft System
®

Carbon Tank Flush

!IMPORTANT!
Do not perform the Carbon Tank Flush until the Carbon Tank Soak process is complete.
Notice:
Water will flow out of the Bypass Valve during this process. Be sure you perform this series of steps
in a location suitable for water flow.
Carbon Flush
Figure 4
1. Reattach the garden hose to the Hose Bib Assembly.
2. Slowly turn on the water 1/4 turn for this process.
3. Run water through the inlet side of the Bypass Valve for 30 minutes to expel the carbon fines.
4. Turn off the water.
5. Remove the Hose Bib Assembly from the inlet side and attach it to the outlet side of the Bypass
Valve.
6. Slowly, fully open the hose spigot.
7. Run the water through the outlet side for 3 minutes to reset the carbon.
8. Turn off the water.
9. Remove the Hose Bib Assembly from the Bypass Valve and disconnect the garden hose.
Note: Please save the Hose Bib Assembly as this will be used in the future for the carbon
exchange.
Carbon Reset
© 2014 Enviro Water Solutions LLC
3060 Performance Circle, Suite 2. DeLand, FL 32724
Water
Garden
Hose
Hose Bib
Assembly
Hose Bib
Assembly
Garden
Hose
Water
INLET
Whole House Water Filter
INLET
Whole House Water Filter
www.envirowaterproducts.com
Rev C
Page 8