Carbon Tank Soak - Enviro NaturSoft Pro Serie Manual Del Proprietário

Enviro Water Products Pro Series Water Filter and
Salt-Free NaturSoft System
®

Carbon Tank Soak

!IMPORTANT!
Your system will not be ready for use for a minimum of 48 hours while the Carbon Soak process takes
place. Please plan your installation accordingly.
Notice:
Water will flow out of the outlet side of the Bypass Valve during this process. Be sure you perform this
series of steps in a location suitable for water flow.
Figure 3
1. Attach a garden hose to the Hose Bib Assembly
2. Connect the Hose Bib Assembly to the inlet side of the Bypass Valve and hand tighten
3. Fill the Enviro Water Products Whole House Water Filter Tank full until water comes out of
outlet side of the Bypass Valve
4. Turn the water off.
5. Remove the garden hose from the Hose Bib Assembly. Do not remove the fitting.
6. Allow the carbon tank to soak for a minimum 48 hours prior to tank installation.
© 2014 Enviro Water Solutions LLC
3060 Performance Circle, Suite 2. DeLand, FL 32724
Garden
Hose
Hose Bib
Assembly
Bypass Valve
Water
INLET
Whole House Water Filter
www.envirowaterproducts.com
Rev C
Page 7