Off; Patch Mode Led; Effects Mode Led; Navigation Mode Led - Blackstar Amplification FS-10 Manual Del Usario

7. LED 3

Off.

8. LED 4
Off.

9. Patch Mode LED

Off.

10. Effects Mode LED

Off.

11. Navigation Mode LED

On.

12. Display

Solid number = current active patch number.
Flashing number = patch number browsed to.

13. Multi function LED

Flashes green twice to indicate a patch has been stored.
Selecting Patches
To switch between non-consecutive patches (e.g. if you are on
patch 19 and you want to select patch 26) browse to the patch
number required and then press Recall (Switch 4).
While searching for the patch you want, the display number will
flash to show a mismatch between the patch currently shown and
the active patch. The number will be solidly lit once the patch is
selected.
8
Storing Patches
To store a patch press Switch 1. The LED above Switch 1 (5) and
the patch number on the display will flash and the LED above
Switch 4 (8) will be lit.
Navigate to the patch number you wish to store into using Switches
2 and 3, and press Switch 1 again to store the patch at the number
displayed. Multi function LED (13) will flash green twice to indicate
that the patch has been stored.
Pressing Switch 4 (4) at any point will cancel the process.

Tuner Mode

1. Switch 1
Press: Return to previous Mode.
2. Switch 2
Press: Return to previous Mode.
3. Switch 3
Press: Return to previous Mode.
4. Switch 4
Press: Return to previous Mode.

5. Switch LED 1

On = note played very flat.
6. Switch LED 2
On = note played slightly flat.
7. Switch LED 3
On = note played slightly sharp.
8. Switch LED 4
On = note played very sharp.
9. Patch Mode LED
Off.
9