Courtyard Creations TCS46JK Instrucciones De Armado página 3

ATTENTION:
Make sure that each bolt needed for all steps
matches the corresponding figure to ensure proper
assembly.
NOTE:
Parts come in more than one carton.
Step 1:
Place the table top (#1) onto a non-abrasive surface,
such as a carpet, with its underside facing upwards.
Fasten the legs (#2) to the underside of the table
top (#1) rim by using bolts (#10), washers (#12), and
plastic nuts (#15). Do not fully tighten the bolts yet.
See Figure 1.
Step 2:
Fasten the center connector ( #3 ) to the middle of
the legs ( # 2) by using bolts ( #11 ) and washers
( # 12). Make sure that all of the bolts have been
tightened completely. See Figure 2.
NOTE:
The arrow marks on the center connector (#3)
should coincide with Figure 2 to ensure proper
assembly.
Step 3:
Turn the table to its upright position. Open the
cartons containing the tiles. Then, put tiles (#4 and
#5) onto the table top. See Figure 3.
NOTE:
1. If the rubber bumpers attached on the table top
are missing, you can replace them with the rubber
bumpers in the hardware kit. See Illustration A.
2. Do not throw the residual tiles away. Keep them
for future use if needed.
V-3
FIGURE 2
FIGURE 3
DO NOT RETURN TO THE STORE!
STOP
PAGE 3 OF 6
FIGURE 1
2
15
12
12
10
15
12
12
10
35
2
2
#11 BOLT M6*25
A
2
2
1
#10 BOLT M6*35
11
3
2
12
2
25
4
2
5