Setting The Time And Date Manually - ADE WS 1600 Instrucciones De Operación

‚ You can start the receiving process again manually,
see "Starting signal reception manually", or
‚ Wait until the base station automatically switches
to receiving mode again at a later point in time. The
reception is usually better at night.
‚ If reception is not possible at your location, you can
set the time and date manually, see next chapter.

Setting the time and date manually

If there is more than approx. 20 seconds between
two pushes of a button, the setting process
automatically ends and you will have to repeat it.
1. Press and hold the TIME button until the indicator for
the 12- and 24-hour time format blinks on the display.
2. Using the
format ("12 hr" or "24 hr").
3. Press TIME in order to save the settings. „00" blinks
on the display (for most countries in Europe, 00 is the
correct setting for the time zone).
4. Proceed as previously described.
5. Press TIME each time to save the settings.
6. Press the
7. Carry out the following settings:
− Hours
− Minutes
− Date format
− Year
− Month
Weather Station with Wireless Outdoor Sensor WS 1600
and buttons, set the desired time
or button to set the desired value.
57