Custom-Cut Baffle Adjustment - Scag SW Serie Manual Del Operador

Custom-Cut Baffle Adjustment

The Custom-Cut Baffle is designed to deliver optimum
airflow and superior cutting performance in any type of
grass. The Custom-Cut Baffle can be raised or lowered
to precisely tailor the deck's performance for the type of
grass being cut. The baffle can be set in three (3)
different positions for optimum performance.
A. 3" Position - baffle is installed using the top set of
holes on the front baffle welded inside the cutter
deck. (See Figure 10). The Advantage cutter deck
will deliver the best quality-of-cut in very tall, wiry,
tough to cut grass.
B. 3-1/2" Position (factory setting) - baffle is installed
using the middle set of holes on the front baffle
welded inside the cutter deck. (See Figure 11).
For general purpose cutting, place the Custom Cut
Baffle in the 3-1/2" position. This gives the best
mix of cutting performance in all types of grass.
C. 4" Position - baffle is installed using the bottom set
of holes on the front baffle welded inside the cutter
deck. (See Figure 12). Placing the baffle in the 4"
setting will enhance fall cutting (leaf pickup) and
reduce cutter deck "blowout".
To adjust the Custom-Cut Baffle height:
1. Remove the hardware securing the Custom-Cut
Baffle to the cutter deck. (See Figure 9).
Hardware location used in the illustrations are
for reference only. Location of hardware may
vary depending on the cutter deck size.
MOUNTING
HARDWARE
Figure 9. Custom-Cut Baffle
-NOTE-
MOUNTING
HARDWARE
2. Move the Custom-Cut Baffle to desired position.
(See Figures 10 through 12 for position)
3. Reinstall the mounting hardware as shown. (See
Figures 11 though 12). Torque hardware to
39ft.lbs.
TOP SET OF HOLES
FOR 3" SETTING
Figure 10. 3" Custom-Cut Baffle Position
MIDDLE SET OF HOLES
FOR 3-1/2" SETTING
Figure 11. 3-1/2" Custom-Cut Baffle Position
BOTTOM SET OF HOLES
FOR 4" SETTING
Figure 12. 4" Custom-Cut Baffle Position
2004 CCB
10
CARRIAGE BOLT
2004 CCB - 3" Setting
ELASTIC STOP
NUT
CARRIAGE BOLT
2004 CCB - 3-1/2" Setting
ELASTIC STOP
NUT
CARRIAGE BOLT
2004 CCB - 4" Setting
ELASTIC STOP
NUT