To Set The Time; To Set The Date - Oakley HOLLOW POINT Manual De Instrucciones

TO ADjuST THE TiME AND DATE FOr SuBSEquENT SETTiNGS, uSE THESE SHOrT PrOCEDurES

TO SET THE TIME

1. Unscrew the crown from the case.
2. Pull the crown out to the second click position (b).
3. Turn the crown until you reach the correct time.
4. Push the crown back in. Gently turn the crown
clockwise while pushing it inward toward the case,
until it screws back into the case. Be careful not to over
tighten the crown, as this will damage the mechanism.
Hollow Point

TO SET THE DATE

1. Unscrew the crown from the case.
2. Pull the crown out to the first click position (a).
3. Turn the crown clockwise until you reach the correct date.
If the current time is between 9 PM and midnight, set
the date to the following day. (This is necessary to
ensure the display will normally change at midnight
instead of 12 noon.)
4. Push the crown back in. Gently turn the crown
clockwise while pushing it inward toward the case,
until it screws back into the case. Be careful not to over
tighten the crown, as this will damage the mechanism.
Setting the date too quickly can result in the incorrect
date being displayed. To restore synchronization,
turn the crown clockwise to go through the range of
date settings (from 01 to 31) when performing the
instructions above.
inStRUCtion MAnUAl | 5
™