Hammerhead HLLT16 Manual Del Usuario página 14

OPERATION
e. Press the "SPR" button to save
the SPR angle in the tool for later
use. "S" shown in the LCD display
indicates that the spring angle is
saved successfully (Fig. 8).
NOTE:
• To recall the saved spring angle,
press the SPR button after the tool is
turned on.
• If the spring angle is already known,
follow steps f-h below, to input the
SPR angles.
f. Press the power button to turn on
the tool.
g. Move the folding leg until the
known spring angle is displayed
on the LCD display; press the
MTR/BVL button to input the SPR
angle. "SPR" will show on the LCD
display (Fig. 9 & Fig. 7).
h. Push the "SPR" button to save this value in the tool; the letter "S" shown
on the LCD display indicates the spring angle is saved successfully (Fig. 8).
14
8
S SPR
9
16" DIGITAL ANGLE FINDER