Setting The Parameters - DAITEM SH402AX Manual De Instalación

GB
Siren recognition programming sequence.
"bip"
Briefly press
the siren "test"
button
iMPoRtAnt: the control panel and siren issue three short beeps to indicate a programming
error. When this happens, perform recognition programming again from the start.

4. Setting the parameters

iMPoRtAnt: all parameter-setting must be done using twinLoad
Daitem installers section at www.daitem.co.uk.
The control panel and siren must be in installation mode to set the siren's parameters. If they
are not, enter:
master code
then
installer code
The siren's parameters are factory-programmed.
Each parameter can nevertheless be modified using the control panel keypad.
To set the siren's parameters, first choose the parameters to be modified and then enter:
siren n°
"bip, off,
control panel"
)
)
)
)
)
Press and hold "off"
until the control panel
responds
parameter parameter
value
n°
"beeeep"
)
)
)
)
)
10 s max.
The siren issues an
audible signal to
confirm programming
"bip, installation
mode"
96
"bip, siren n°"
The control panel
announces
the siren n°.
software available in the
®
"bip, installation
mode"