Assembly - Truper ASPI-16X Manual Del Usuario

Assembly

• Disconnect the power cord from the power source.
• Open the container to remove all the accessories as indicated in page 5.
E
• Turn the container upside-down and insert the two wheels (A) into the base and in the front orifices.
• Insert the wheels axis (B) in the base. Set a washer in the axis and then the rear wheel. Set another washer
after the wheel is set. Insert the pin (C) in the orifice found at the axis end to secure the wheel. Repeat the
same steps in the other side of the axis.
A
B
D
C
• Turn the container back to stand on the wheels and
install the carrying handle into the two lateral holders (D).
Turn the power cord hooks (E) to fix the handle in place.
F
• Install the cartridge filter or foam filter depending on the
material to vacuum (see page 8).
CAUTION
Remember to use the vacuum cleaner
with one of those filters installed otherwise the motor will
get damaged and the warranty will be void.
H
• If vacuuming dusts, fix the tongue (F) in the collecting
pouch inside the vacuuming port. Use care not to damage
the pouch.
• Set the motor cap onto the container, aligning the upper
section with the latches. Hook the latches (G).
• Insert the thread side of the hose (H) into the vacuuming
port and turn until it stops.
• Tighten the threaded end of the drain hose to the
container drain outlet (I) and fasten the other side in the
upper holder (J).
• Set the accessories pouch in the carrying handle using
the strings.
• Select the desired accessories and push them into the
suction wand.
G
J
Hose side
without thread
Nozzles
I
Regulating wand Adapter
7
Extension wand