Ticall Software; Configuration - Bticino 342630 Instrucciones De Empleo

item 342630

TICALL SOFTWARE

The TiCall software can program all the parameters in the device configuration menu, using
a PC with Microsoft operating system.
The functions described above can be programmed when the device is already installed,
by means of SCS bus, or before installation (just power the speaker module), connecting it
to the PC RS232 port by means of the serial interface cable (item 335919). To transfer the
programming the module display must show the initial page (rest position).
By assigning a name to each custom programming, the filing can be managed like any
other file.
The software can also update the device
firmware and replace the "Custom"
language with a predefined language by
mans of the serial interface cable (item
335919).

CONFIGURATION

P - entrance panel number
The configurator inserted in socket P of the
speaker module assigns it a recognition number
inside the system.
The main entrance panel must not be configured
in P, while all the other entrance panels must be
numbered progressively.
T - door lock relay timing
configurator number
0 = No
1 2
configurator
1 2
4 sec.
sec. sec. sec.
3 4 5 6 7
3 as 6 8 10
pushbutton sec. sec. sec.
item 335919
J3 J1
Loudspeaker volume
adjustment
Microphone sensitivity
adjustment
S - type of call signal
The configuration of S determines the tone of the
internal unit call. The calls from different entrance
panels can thus be differentiated.
Configurator 0
Type of ring tone Two-tone Two-tone Two-tone
1200 Hz 1200 Hz 1200 Hz
600 Hz
J4 - confirm call on EP
Remove jumper J4 to eliminate the call tone on
the entrance panel.
88
1 2 3
one-tone
1200 Hz
0 Hz 2400 Hz