KCTE-80
Thermal Imager
7.3.8-Factory Set
1-In Settings submenu, press "up" and "down" button, highlight "Factory Set"
2-Press "select" button, popup "Factory Set" submenu.
3-Press "OK" to restore factory setting, "Cancel" to exit without change.
Factory Settings of the Thermal Imager is as follow:
Image prItem
Measurement
Measurement Parameters
Image
System Setting
Parameter
Center Spot Measurement
Hot Spot Measurement
Cold Spot Measurement
Emissivity
Reflective temperature
Mode
Palette
Adjustment
Language
HDMI Output
Laser
Lamp
Value
off
off
off
0.95
25°C
Infrared
Iron
Auto
English
off
off
off
www.grupotemper.com