Combination Locks; Setting And Resetting The Combination Lock; Using The Combination Lock - Tripp-Lite SmartRack SR25UB Manual Del Propietário

5. Enclosure Configuration
5.5 Combining (Baying) Enclosures
4
Connect each bracket to the adjoining enclosure using the screws you removed in step 2, but do not tighten
the screws completely. Adjust the position of the enclosures as needed. If you want the centers of the
enclosures to be 24 inches (61 cm) apart, use the outside hole of the bracket
be 60 cm (23.6 inches) apart, use the middle hole of the bracket
confirming that the enclosures do not need further adjustment, tighten all screws.
Note: You may wish to remove the doors from the enclosures before combining them. Reinstalling the doors
afterward is optional. Remove the interior side panels before baying enclosures if you wish to enable
access between enclosures.

6. Combination Locks

Insert key into lock. Turn key 180 degrees counterclockwise so that indicator arrow points UP as
shown. Lift handle and turn. To re-lock, turn key 180 degrees clockwise so that lock indicator arrow
points DOWN as shown and remove key. (Note: Using the key overrides the combination lock
feature.)
Note: One key is provided for side panels, and another is used for combination locks. Using the key overrides the
combination lock feature. Typically, the rack's owner will have access to this key, while subsequent users
will have access to their own sections of the rack via the Combination Lock Feature.

6.1 Setting and Resetting the Combination Lock

(Note: To set or reset the combination lock feature, the lock must be engaged and the existing
combination must be known. The lock comes with the combination factory preset to 0-0-0.)
a. Dial in the existing combination.
b. Turn wing knob 180 degrees counterclockwise so that lock indicator arrow points UP.
c. Turn wing knob an additional 15 degrees counterclockwise.
d. Enter the new combination.
e. Turn wing knob 15 degrees clockwise. The new combination is now set.
f. To re-lock, turn wing knob 180 degrees clockwise so that lock indicator arrow points DOWN as
shown; then scramble the combination.

6.2 Using the Combination Lock

Dial in the combination. Turn wing knob 180 degrees counterclockwise so that lock indicator arrow
points UP as shown. Lift handle and turn. To re-lock, turn wing knob 180 degrees clockwise so that
the indicator arrow points DOWN as shown; then scramble the combination.
( continued )
( continued )
C
. If you want the centers to
D . After connecting all brackets and
10
D
C
4
3
1
Combination Lock Dials
2
Lock Indicator Arrow
3
Wing Knob
15°
Locked Position Unlocked Position
1
2
180°