Craftsman 580.752140 Instrucciones De Uso página 13

How to Stop Your CJeaningSystem
1= Reieasespray gun trigger and let engine idte for two
minutes.
2. Move throttie to SLOW position, then STOPposition.
WARNING
,,_ Backfire, fire or engine damagecouId occur.
o DONOTstopenginebymovingchokeleverto "Cheke"position.
3. ALWAYSpoint spray gun in a safe direction and squeeze
spray gun trigger to releaseretained high water pressure.
iMPORTANT: Spray gun traps high water pressure, even
when engine is stopped and water is disconnected.
WANNING
The high pressure stream of water that this
equipment produces can cut through skin and its
_ nderlying tissues, ieading to serious injury and
)ossibieamputation.
Spray gun traps high water pressure, even when
engine is stopped and water is disconnected,
which can cause injury.
, Keephigh pressurehoseconnected to purnpand spraygun
whilesystemis pressurized.
o ALWAYS pointspraygun in safedirectionand squeeze spray
gun trigger,to release high pressure everytime you stop
engine.Engage trigger lockwhennot in use.
4. Engagetrigger iock on spray gun when not in use.
How to Use Accessory Tray
The unit is equipped with an accessory tray with piaces to
store your ProjectPro
TM
nozzles, HydroFoam
TM
launcher, spray
gun and nozzleextension. There is aiso a hook at the front of
the accessory tray to hold your high pressure hose. Identify
ali accessories with the iiiustration on page 6.
NOTE:The extra hoie in the tray is for storing a utiiity brush.
The extra clip in the tray is for storing a turbo nozzle.The
brush and turbo nozzle are NOT included with your pressure
washer. You can buy these items as optional accessories.
1. Place nozzle extension through hole on accessory tray,
as shown.
.
3.
4.
.
Mace spray gun through hole on accessory tray on right
side of unit.
Insert multi-coIored ProjectPro
TM
nozzlesin spaces
provided in accessory tray.
Insert HydroFoam
TM
iauncher in space provided in
accessory tray next to the multi-colored ProjectPro
TM
nozzles.
Hang high pressure hose on hook attachedto accessory
tray on front of tray as shown.
How to Use ProjectPro
TM
Nozzle System
The quick-connect on the nozzle extension aliows you to
switch between three different ProjectPro
TM
system nozzles.
ProjectPro
TM
nozzlescan be changed while pressure washer
is running once spray gun trigger lock is engaged. The
ProjectPro
TM
nozzlesvary the pressure and spray pattern as
shown.
High Pressure
Delicate General Max
40° Yellow 15° Orange 0° Red
2350 PSI 2675 PSI 3000 PSi
2.7 GPM 2.5 GPM 2.3 GPM
Fellow these instructionste changeProjectPro
TM
nozzles:
1. Engagetrigger lock on spray gun.
WARNING
The high pressure stream of water that this
_ quipment produces can cut through skin and its
underiying tissues, ieading to serious injup/and
_ossible amputation.
o NEVER exchange ProjectPro
TM
nozzles without lockingthe
triggerlock on the spraygun.
• DONOTtwist ProjectPro
T M
nozzles whilespraying.
2. Puii back collar on quick-connect and puii current
ProjectPro
TM
nozzle off. Store ProjectPro
TM
nozzlesin
holder provided on the accessory tray.
13