To keep all your coffee's aroma and to avoid a degradation of the ground coffee,
empty the ground coffee holder after each use.
Always disconnect the grinder before cleaning.
Never place the grinder, power supply cord or plug in water or under running water.
Do not use strong detergents or abrasive pads to clean the appliance.
Clean the lids and the ground coffee holder in warm, soapy water.
To remove the upper burr (5), set the fineness selector (9) to the fine position then
take hold of the winglets of the upper mill with your fingers and turn clockwise, then
raise it vertically to remove. (Fig. A)
Clean the upper burr with the cleaning brush (11). (Fig. B)
Carefully clean the inside of the coffee-bean hopper (1) with a damp cloth.
To replace the upper burr, set the fineness selector (9) to the coarse position, insert
the burr and turn it once in the counter-clockwise direction. (Fig. A)
Carefully clean the ground coffee dispenser (10) and the body of the appliance with
a damp cloth.
TROUBLE SHOOTING GUIDE
The appliance does not
work.
The appliance stops during
operation.
The fineness selector does
not work anymore.
MAINTENANCE
Check the electrical connection.
The lid of the coffee bean hopper is not correctly closed.
The ground coffee holder is not correctly positioned or
the lid is not correctly positioned or is not in place.
The appliance has overheated.
The overheat protection mechanism has been activated.
Unplugged the appliance.
Detach the upper burr for cleaning and remove any
obstacle.
Leave the appliance to cool down for 30 minutes before
next use.
If the appliance is still not working, you have to contact
an approved service center.
Causes of overheating to be avoided:
The maximum capacity of beans in the bean hopper, or
the maximum capacity of ground coffee in the ground
coffee holder has been exceeded.
Check that the upper burr is correctly positioned. (See
paragraph concerning the maintenance in the manual).
4