Control Buttons - Fermax iLOFT VDS Guía Inicio Rápida

START GUIDE FOR MONITOR iLOFT VDS

CONTROL BUTTONS

Inductive loop,
(depending on
model)
HOW TO PROGRAM THE iLOFT MONITOR
1. INSTALL
Monitor powered for the fi rst time.
The blue led blinking slowly indicates that the monitor has not been
programmed.
2. PROGRAMMING
PROGRAMMING FROM THE PANEL (Panel confi gured as MASTER)
1. With the monitor on, press the programming button. A confi rmation tone will be emitted.
2. Press the call-to-residence button. Again, a confi rmation tone is emitted.
Note: The monitor will not work if it has not been programmed.
1
2
VDS ILOFT MONITOR
Audio activation and hang-up (hands-free functions) and Digital
menu for internal parameter settings and confi guration. (When the
monitor has already been programmed).
In conversation, press to open the door.
In standby, call to guard unit (if applicable).
Auxiliary functions, (contact your installer).
In standby, press and view the main panel´s camera. Auto-start and
select Main/Secondary camera (depending on the installation).
iLOFT monitor incorporates an OSD menu that is managed via the monitor´s
push buttons to access the terminals´user and programming functions.
The icons displayed are managed with the corresponding buttons located
on the monitor.
PROG: programming button
< 2 min. 30 sec.
2

Cod. 97879 V10_16