Installation Guide; Installation Hardware - Panasonic CQ-R221U Manual De Instrucciones

Installation Guide

This installation information is designed for experienced installers
and is not intended for non-technical individuals. It does not contain
warnings or cautions of potential dangers in attempting to install
this product.
Any attempt to install this product in a motor car by anyone other
than qualified installer could cause damage to the electrical system
and could result in serious personal injury or death.
Overview
This equipment should be installed by a
professional. However, if you plan to install this
unit yourself, your first step is to decide where
to install it. The instructions in these pages will
guide you through the remaining steps: (Please
refer to "WARNING" statement above).
Identify and label the vehicle wires.
Connect the vehicle wires to the wires of the
power connector.
Install the unit in the dash board.
Check the operation of the unit.
If you do encounter problems, please consult
your nearest professional installer.
Caution: This unit will operate with a 12 volt
DC negative ground auto battery system only.
Do not attempt to use it in any other systems.
Doing so could cause serious damage.
Before you begin installation, look for the
following items included in the packing with
your unit.
Warranty Card . . . . . . . . . . . . .Fill this out promptly
Panasonic Servicenter for service
Directory . . . . . . . . . . . . . . . . .Keep this for future reference in case the unit needs servicing
Installation Hardware . . . . . . .Needed for in-dash installation
WARNING

Installation Hardware

No.
Mounting Collar
Hex. Nut (5 mm φ )
Rear Support Strap
Tapping Screw
(5 mm φ x 16 mm)
Mounting Bolt (5 mm φ )
Power Connector
Dismounting Plate
Removable Face
Plate Case
Item Diagram
CQ-R221U
E
N
G
L
I
S
H
12
Qty
1
1
1
1
1
1
1
1
21