KS ALAMO Serie Manual De Instalación Y Funcionamiento página 5

INsTALLATION
sTEP 4 – CONNECTING ThE POWER sOURCE
This product includes a self adjusting sensor. The ideal sensor range for the
specific location will be set automatically.
Important: Check that no objects are
1
in front of the sensor besides the
washbasin.
Now, remove the protecting sticker
2
that covers the sensor.
If your model is Àlamo or Álamo
Dúo (internal battery models):
wait about 30 seconds in order
to allow the system to set the
ideal sensor range. After the self
adjustment has taken place the the
solenoid valve will open and close
for 1 second and a small amount of
water will be leave the spout. Then the
product will be ready for use.
3
If your model is operated by external battery:
Install the battery box on the wall underneath the sink using the two
sided adhesive foam tape. The cable connection must point down. (You
can use an optional extension cable in order to assemble the battery
box up to 10ft. away from the sink.)
If your model is transformer operated:
Plug the transformer into the electricity socket and connect the
connectors.
6
INsTALLATION
ABOuT
3O
sECONDs
sTEP 4 – CONNECTING ThE POWER sOURCE
wait about 5 seconds in order to allow
the system to set the ideal sensor range.
After the self adjustment has taken place
4
the solenoid valve will open and close for
1 second and a small amount of water will
be leave the spout. Then the product will
be ready for use.
If the obtained range is unsatisfactory, refer to the section entitled
5
"Settings adjustment" .
NOTE: This model includes a special aerator that
allows you to adjust the water stream direction
on site in order to prevent water splashing if
needed. To change the angle of the water stream,
simply move the adjustable tilting plate by
pressing it smoothly.
ATTENTION! the aerator is tightened to prevent
removal by hand.
ABOuT
5
sECONDs
7