Jotul F 3 Manual De Instalación Con Información Técnica página 17

4.0 Service
Warning! Any unauthorised change to the product is illegal!
Only use original spare parts!
4.1 Replacing the Air Chamber
Remove the door to avoid any damages to the glass or enamel.
Disconnect the top plate of Jøtul F 3. This is connected to the side
plates with 2 collar head screws - one on each side. See fig. 3.
Remove these with the Allen key which are supplied with the
stove.
In the case of side/rear connection, the following should
be done:
1. Unscrew the heat shield (fig. 4B). It will then be possible
to use a screw driver to keep in place the screw which is
situated there.
2. Unscrew the nuts under the air chamber at the back edge
(towards the back wall), one on each side (fig. 7).
3. The air chamber is fastened at the front to the side burn
plates with the screws (fig. 8). These are loosened and the
air chamber can then be lifted out from above.
In the case of top connection, the following should be
done:
• Lift out the ash moulding (the log stopper).
• The air chamber is lifted out through the door opening with
one hand, while at the same time flipping in and pulling out
the one of the side burn plates.
The air chamber may now be lowered diagonally and twisted
out via the door opening.
Assembly of a new air chamber
Follow the same procedure in reverse order.
4.2 Changing the burn plates/inner
base plate
Follow the same procedure as for: «4.1 Replacing the Air
Chamber».
Defected parts can be removed and replaced once everything is
loosened. First remove the side burn plates, then the back burn
plate. Finally, the inner base plate is then removed. If the parts
get somewhat stuck, use a large screwdriver or something similar
to flip them loose. When assembling, the same procedure is
followed in reverse order.
NB! Important notice!
Ensure that the insulation sheet behind the burn plates, together
with all of the gaskets, are intact before assembly takes place. It
may also be necessary to change some screws and nuts.
5.0 Optional equipment
5.1 Firescreen - cat. no. 350166
If the stove is being used with the door open, always use a
firescreen. It is affixed by two claws at its bottom edge and a
spring clip which is pressed into the door opening at the top.
5.2 Floor plate
A decorative enamel floor plate is available for your Jøtul F 3.
The dimensions of the plate are: 632 x 772 x 16,5 mm
5.3 Decorative ring - cat. no. 350466
When the cover in the top plate is removed a small opening
is created between the smoke outlet and the smoke pipe. The
opening can be covered by a decorative ring. The ring can be
delivered in the colours of the fire place.
english
17