Bell COCOON 300 Manual De Instrucciones página 4

STEP 3
Remove the seat post clamp bolt from your bicycle.
Attach the U-bracket using a 8mm x 58mm Hex Bolt,
8mm Split Lock Washer and 8mm Nylock Nut.
11
HARDWARE NEEDED FOR
STEP 3, 4 & 5
ITEM #22
8mm
Split Lock Washer
Steps 3, 4 & 5
ITEM #20
ITEM #21
8mm x 58mm
8mm
Hex Bolt
Nylock Nut
Steps 3 & 4
Steps 3, 4 & 5
STEP 4
Position right and left seat supports on both sides of U
bracket. Insert spacer tube and secure using a 8mm x
58mm Hex Bolt. 8mm Split Lock Washer and 8mm
Nylock Nut. Hand tighten at this time.
11
14
3
2
15
ITEM #19
8mm x 30mm Round
Hd. Sq. Neck Bolt
Step 5 Only
ITEM #15
Plastic Thread
Protector
Steps 3 & 4
15
STEP 5
Assemble long lower brackets to rear stay of bicycle by
sliding vinyl paint protectors over all four brackets and
inserting the short lower bracket into the slotted end of
the long lower bracket and twisting into position. Insert
8mm x 30mm Round Hd. Sq. Neck Bolt and secure
with 8mm Split Lock Washer and 8mm Nylock Nut.
23
NOTE: The child carrier must be in a level position
when installed. Several adjustment holes are provided
in the U bracket which will enable you to clear all
obstructions and level the carrier. Tighten all fasteners
securely. Place plastic thread protector (item #15) onto
8mm x 58mm Hex Bolt used in Steps 3 & 4.
STEP 6
Remove Foot Guard, Spring Guards and Foot Guard
Fasteners from plastic sheet. Install foot guard by
wrapping it over the top of the right and left seat
supports and tucking it under the front edge of the
seat. Secure foot guard to bicycle frame by inserting
fasteners through slots in foot guard and around the
bicycle frame. If bicycle has exposed springs, wrap
spring guards around springs.
Spring Guards
5
Spring Guard
Foot Guard
6
Foot Guard
Fastener
13
12
Foot Guard
Fasteners
Foot Guard
Plastic Sheet
Spring Guard
6
Foot Guard
Fastener
4
Fasteners