Carlisle Binks QS-5012-1 Manual De Servicio página 10

EN
Air motor sluggish or inefficient.
AIR MOTOR REBUILD
(SEE EXPLODED VIEW OF 31-418-1 ON PAGE 4.)
Do not pry dead end plate (21) or drive end plate (27) from
air motor body (23) with a screwdriver. This will dent the
surface of the body and plates and causing leaks. A puller tool
should be used to remove the plate from the motor body
while maintaining the positions of the shaft.
Always install new gaskets (22) when re-assembling air motor.
Assemble the end plates to the body using an arbor press with
a pusher acting on both races of the bearing while rigidly
supporting the opposite (drive) end of the shaft.
GEAR-MOTOR
(SEE EXPLODED VIEW OF 31-391-1 ON PAGE 4.)
When assembling the air motor to the gearbox, apply grease
to the O.D. of the air motor shaft and the I.D. of the gearbox
shaft. Recommended grease: 41-4458-K.
www.carlisleft.com
AIR MOTOR DRIVE SERVICE CHECKS
Air motor needs lubrication or cleaning.
Motor vanes need replacing or
contaminants present in motor chamber.
Air motor bearing (18 or 28) worn.
10 / 12
Lubricate (see "Air Motor Lubrication"
section). Disassemble and clean per parts
replacement instructions.
Disassemble, clean motor per parts
replacement instructions. Replace worn
vanes.
Replace bearings per parts replacement
instructions.
77-2990-R3.2 (5/2017)