Leggett & Platt Performance Serie Manual Del Usaurio página 25

"PRESS & HOLD" TO "ONE TOUCH" PROGRAMMING (1 remote control - 2 bases)
TO CHANGE FROM "PRESS & HOLD" TO "ONE TOUCH" PROGRAMMING
STEP 1
Adjust base to the flat position.
STEP 2
Simultaneously press the HEAD MASSAGE DOWN and FOOT MASSAGE DOWN buttons on either of the remote
controls. The massage motors will turn on and off confirming the change.
WHEN IN "ONE TOUCH" MODE:
Cust 1 and Cust 2 buttons
One touch button. Base will adjust to the programmed position. Press any other button to stop the base during
movement.
Flat button
One touch button. Base will shut off massage motor, if active, and adjust base to level position. Press any other
button to stop the base during movement.
REVERT BACK TO FACTORY SETTINGS
To revert back to factory settings, simultaneously press and hold the SET button and the FLAT button on either
of the remote controls. The massage motor will turn on and off confirming the change. Your base is now set to
factory settings.
25
Performance Models Scape/Scape+ Owners Manual 99301472-c