Before First Use; Wall Mounting - Vollrath 47703 Manual Del Usaurio

INSTALLATION
This cutter can mounted to a table or a wall.
Table Mounting
Use four ¹⁄₄" screws (customer supplied) of a suitable length and
appropriate type to mount the cutter.

Wall Mounting

Use four ¹⁄₄" screws (customer supplied) of a suitable length and
appropriate type to mount the cutter.
Wall mounting bracket (item no. 45682) available. Sold separately. See
Vollrath.com for information.
NOTICE: When mounting to a wall, ensure that the screws are
installed into studs. If this is not possible, use the proper
anchors and screws to secure the base.
FEATURES
A
B
C
D
E
F
G
A Handle
B Cotter Pin and Pin
C Pusher Block Screws
D Pusher Head Assembly
E Pusher Head Bock. Must match the blade assembly.
F Guide Rods
G Blade Assembly. Must match the pusher head block.
H Blade Assembly Nuts
I Mounting Holes
2

BEFORE FIRST USE

Clean the equipment. Wash the blade assembly and pusher block head
with warm soapy water. Rinse thoroughly.
OPERATION
Sharp Blade Hazard
Blades are sharp and can cause cuts. To avoid injury from
sharp blades, handle with caution.
1. Before each use, check that the equipment is clean and that the
blades are in good condition. Do not use this equipment if blades are
loose or broken.
2. Verify that the blade assembly and pusher head assembly are the
desired size and are a matching set.
3. Check the blade alignment by slowly setting the pusher head onto
the blade assembly. They should slide together with no obstructions.
4. Prepare the food to be processed. Maximum size of the food product
is 3¹⁄₈" (7.9 cm) in diameter and 6" (15.2 cm) in length.
5. Lift the handle and place the food on the blade assembly with the flat
side down.
6. Remove hands from the blade assembly area.
7. Use a strong, quick thrust to push the food through the blade
assembly.
8. Repeat this process until you have cut enough food for your needs.
9. Immediately clean and lubricate this equipment.
NOTICE: Food acids dull the blades and corrode the metal. Always
I
I
H
Potato Cutters and Wedger Operator's Manual
WARNING
clean this equipment immediately after use.