Local Communication; Remote Communication; Remote Communication Via External Modem - Ingeteam INGEREV Serie Manual De Instalacion Y Uso

Ingeteam
3. Thread the cabling through and tighten the packing gland. Leave margin so that the cabling is not tense.

4.2. Local communication

INGEREV GARAGE charging stations have a local RS-485 data bus with an RJ45 connector that
enable interconnection between the stations. Consult the corresponding installation manual for more
information on this subject.

4.3. Remote communication

To enable remote connections via Ethernet or using a USB modem in INGEREV GARAGE charging stations it is
necessary to remove the cable that shows in the figure below. This cable is supplied for local connection.

4.3.1. Remote communication via external modem

1. Connect the communications card with Ethernet connection to one of the charging stations located at one
end of the installation in order to start the communication ring. It can be connected both with the J15
and J17 connectors, as well as the J16 and J18 connectors.
20 ABA2017IQM01_A - Installation and Operation Manual
INGEREV GARAGE