Open fuel filler cap.
Refill fuel.
Close tank lock.
Wipe off spilled fuel.
Fill/replace detergent container
DANGER
Risk of injury!
– Under no circumstances vacuum sol-
vents (petrol, aceton, diluting agent
etc.).
– Avoid eye and skin contact.
– Observe safety and handling instruc-
tions by the detergent manufacturer.
Fill/replace external detergent container.
Water connection
For connection values refer to technical
specifications.
Attach supply hose (minimum length
24.6 ft/7.5 m, minimum diameter 1/2")
to the water supply set by means of a
hose clamp.
Connect the supply hose to the water
connection point of the machine and at
the water supply point (for e.g. a tap).
Note: The supply hose and the hose clamp
are not included in the scope of delivery.
Suck in water from vessel
Connect suction hose (minimum diame-
ter 1/2") with filter (accessory) to the
water connection point.
– Max. suck height: 1.6 ft (0.5 m)
DANGER
Risk of personal injury or damage! Never
suck in water from a drinking water contain-
er. Never suck in liquids which contain sol-
vents like lacquer thinner, petrol, oil or unfil-
tered water. The sealings within the device
are not solvent resistant. The spray mist of
solvents is highly inflammable, explosive
and poisonous.
Power connection
– For connection values, see technical
data and type plate.
– The electrical connections must be
done by an electrician according to IEC
60364-1.
Set the appliance switch to "0/OFF".
Plug in the mains plug.
GFCI INSTRUCTIONS
STEP 1: Plug the Ground Fault Circuit
Interrupter (GFCI) into a working outlet.
STEP 2: Press ''TEST'', then press
''RESET'' to assure proper connection
to power.
Note: The actual appearance of the
GFCI may be different from this illustra-
tion.
DANGER
Risk of explosion!
Do not spray flammable liquids.
DANGER
Risk of injury! Never use the appliance
without the spray lance attached. Check
and ensure proper fitting of the spray lance
prior to each use. The screw connection of
the spray lance must be finger-tight.
DANGER
Risk of injury! Hold the hand spray gun and
the spray pipe firmly with both hands.
ATTENTION
– Risk of damage! Never operate device
with an empty fuel tank. The fuel pump
will otherwise be destroyed. This also
applies to cold water operation.
– 4
EN
Operation
9