To Add, Reprogram Or Change; Keyless Entry Pin - Craftsman 139.53990DS Manual Del Propietário

To Add, Reprogram or Change a Keyless Entry PIN
NOTE: Your new Keyless Entry must be programmed to operate your garage door opene_
USING THE "LEARN" BUTTON USING THE MOTION DETECTING CONTROL CONSOLE
• Press and release the "learn" button
on motor unit. The learn indicator
light will glow steadily for 30
seconds.
2. Within 30 seconds, enter a four digit
personal identification number (PIN)
of your choice on the keypad• Then
press and hold the ENTER button•
3. Release the button when the motor
unit lights blink• It has learned the
code. If light bulbs are not installed,
two clicks will be heard•
\1 /
To change an existing, known PIN
If the existing PIN is known, it may be changed by one
person without using a ladder•
1. Press the four buttons for the present PIN, then press
and hold the # button•
The opener light will blink twice• Release the # button•
2. Press the new 4-digit PIN you have chosen, then
press Enter•
The motor unit lights will blink once when the PIN has
been learned•
Test by pressing the new PIN, then press Enter• The door
should move.
To set a temporary PiN
You may authorize access by visitors or service people
with a temporary 4-digit PIN. After a programmed number
of hours or number of accesses, this temporary PIN
expires and will no longer open the door. It can be used to
close the door even after it has expired• To set a temporary
PIN:
1. Press the four buttons for your personal entry PIN (not
the last temporary PIN), then press and hold the
button.
The opener light will blink three times. Release the
button.
NOTE: This method requires two people ff the Keyless
Entry is already mounted outside the garage.
Enter a four digit personal
identification number (PIN) of your
choice on the keypad. Then press
and hold ENTER.
While holding the ENTER button,
press and hold the LIGHT button on
the Motion Detecting Control
Console.
Continue holding the ENTER and
LIGHT buttons while you press the
push bar on the Motion Detecting
Control Console (all three buttons
are held).
Release buttons when the motor
unit lights blink. It has learned the
code. If light bulbs are not installed,
two clicks will be heard.
\1 /
2. Press the temporary 4-digit PIN you have chosen, then
press Enter•
The opener light will blink four times•
3. To set the number of hours this temporary PIN will work,
press the number of hours (up to 255), then press =_.
OR
3. To set the number of times this temporary PIN will work,
press the number of times (up to 255), then press #.
The opener light will blink once when the temporary PIN
has been learned•
Test by pressing the four buttons for the temporary PIN,
then press Enter• The door should move. If the temporary
PIN was set to a certain number of openings, remember
that the test has used up one opening• To clear the
temporary password, repeat steps 1-3, setting the number
of hours or times to 0 in step 3.
One Button Close: Opener can be closed by pressing only the ENTER button if the one button close feature has been
activated• This feature has been activated at the factory• To activate or deactivate this feature press and hold buttons 1 and 9
for 10 seconds• The keypad will blink twice when the one button close is active• The keypad will blink four times when one
button close is deactivated•
36