Cassette Operation - auna Oakland Manual Del Usaurio

EN
IMPORTANT!
36

CASSETTE OPERATION

1. Turn the volume knob clockwise to turn the equipment on.
2. Use the function selector to select TAPE/AUX mode.
3. Insert a cassette with the tape facing away from you, as illustrated on the
right. The EJECT/FAST FORWARD button will pop out and the system will
start playing the tape automatically.
4. Turn the volume knob to your desired level.
5. To fast forward the cassette tape, press the EJECT/FAST FORWARD
button halfway down while the cassette is playing. The tape will be
advanced forward rapidly.
6. To resume normal playback, slightly press the EJECT/FAST FORWARD
button again. The button will fully pop out again.
7. To stop playback, press the EJECT/FAST FORWARD button completely.
Playback will be stopped and the cassette tape will be ejected.
When using the cassette deck:
• Make sure to insert the cassette in the correct direction.
• To avoid damaging the cassette, we strongly recommend taking it out
of the equipment after playing the cassette.
Cassette encoding
1. Set the function button to TAPE/AUX mode and then insert a memory
device (USB drive, SD or MMC card).
2. Press the  REC button, it will take 3 - 4 second to read the memory
device, then the USB or SD icon will be flashing on the LC display.
3. Press the skip up  or skip down  button to select the desired mode
(USB or SD) for encoding, then press the record  REC button again to
confirm. (You can skip this step if only a USB drive or an SD/MMC card is
inserted.)
4. The system will start the encoding mode after a few seconds. Insert your
cassette into the playback slot. During encoding, the USB or SD icon will
be flashing on the display.
5. To finish encoding, press the stop  button. The display will show "END"
and return to TAPE/AUX mode.
Notes:
• The recording format is preset at MP3 bit rate 128 kbps.
• The recording speed is 1:1. Recording will take as long as playing the
record.