Care Of Your Opener - Craftsman 139.53915D Manual Del Propietário

THE REMOTE CONTROL BATTERY
CARE OF YOUR OPENER
LIMIT AND FORCE ADJUSTMENTS:
Weather conditions may cause
FORCE CONTROLS
some minor changes in door
operation requiring some re-
adjustments, particularly during
the first year of operation.
Pages 27 and 28 refer to the
limit and force adjustments. Only LIMIT CONTROLS
a screwdriver is required. Follow _ I
the instructions carefully. _ (D_ _r=@
Repeat the safety reverse test
(Adjustment Step 3, page 29)
after any adjustment of limits or force.
MAINTENANCE SCHEDULE
Once a Month
• Manually operate door. If it is unbalanced or binding,
call a trained door systems technician.
• Check to be sure door opens & closes fully. Adjust limits
and/or force if necessary (see pages 27 and 28).
• Repeat the safety reverse test. Make any necessary
adjustments (see Adjustment Step 3).
Once a Year
• Oil door rollers, bearings and hinges. The opener does
not require additional lubrication. Do not grease the door
tracks.
To prevent possible SERIOUSINJURYor DEATH:
• NEVER allow small children near batteries.
• If battery is swallowed, immediately notify doctor.
To reduce risk of fire, explosion or chemical burn:
• ReplaceONLYwith 3V2032 coin batteries.
• Do NOT recharge, disassemble, heat above 100°C (212°F) or
incinerate.
The lithium battery should produce
power for up to 5 years.
Open this end
first to avoidJ {...._
To replace battery, use the visor clip cracking _ d_-"_:'._/-"_J
or screwdriver blade to pry open the hous_
case as shown. Insert battery
positive side up (+).
Dispose of old battery properly.
Replace the battery with only 3V2032 coin cell batteries.
NOTICE: To comply with FCC and or Industry Canadarules (iC), adjustment or modifications of this
receiver and/or transmitter are prohibited, except for changing the code setting or replacing the
battery.THERE ARE NO OTHERUSERSERVICEABLE PARTS.
Tested to Comply with FCC Standards FORHOME OR OFFICEUSE. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and (2) this device
must acceptany interference received,including interferencethat may cause undesiredoperation.
32