Maytag W10551723A Instrucciones De Uso página 8

Reverse Freezer Door
1. Remove the three cabinet hole plugs from the top of the
cabinet and place them in the hinge holes on the opposite
side.
A
2. Remove the two screws from the bottom of the freezer door
handle.
3. Slide the handle downward to release it from the keyhole slot
and pull the handle away from the door.
A. Freezer handle
4. Using the plastic tool (provided), remove the brand badge
from the freezer door by prying up the right-hand side and
slowly peeling the badge away from the door, revealing the
hole to mount the door handle.
NOTES:
To avoid scratching the finish, do not use a sharp or
metallic object to pry the brand badge from the door.
Rub a small amount of liquid dish soap over any adhesive
residue with your fingers. Rinse the door with warm water
and dry with a soft cloth.
5. Remove the shoulder screw from the left-hand side of the
door and fasten it into the hole that was behind the brand
badge.
6. Align the keyhole slot in the handle mounting bracket with the
shoulder screw. Position the handle so that the mounting
base is flush against the door. Slide the handle upward until it
locks into place.
A. Freezer handle
8
A
B
B. Flat-head handle screws
A
B
B. Flat-head handle screws
7. Fasten the bottom of the handle to the bottom of the freezer
door.
8. Remove the door stop from the bottom of the freezer door.
A. Door stop screw
B. Door stop
9. Move the door stop to the opposite side making sure that the
hole in the door stop plate is aligned perfectly with the hole
for the center hinge pin.
10. Using the screw removed in Step 9, fasten the door stop to
the bottom of the freezer door.
A. Door stop screw
11. Tighten all screws. Set aside the freezer door until the hinges
and refrigerator door are in place.
Reverse Refrigerator Door
1. Remove the door stop from the bottom of the refrigerator
door.
A. Door stop screw
B. Door stop
1. Replace the door stop on the opposite side of the refrigerator
door, making sure that the hole in the door stop plate is
aligned perfectly with the hole for the bottom hinge pin.
2. Fasten the door stop to the door.
3. Remove the screws from the top of the refrigerator door
handle.
A B
A
A B