REMOCON 60 / 100 Manual Del Usario página 20

Garage Door Opener 60 / 100
English
emergency STOP device for interruption of power supply to the opener if required;
09 - Once the risks have been analyzed, install the opener and relative safety devices, emergency
STOP and/or photoelectric cell;
10 - When installing the opener, strictly follow all the instructions given in the instruction manual; if some
points are not clear do not install the unit until all doubts have been cleared up with our technical
department.
Description of the Connections (fig. 08)
1 - 24V+ to Flash Lamp (max. 5W)
2 - START button (wall or key selector)
3 - Photocells contact (NC)
4 - GND (power negative, common for photocells and START)
5 - 24V+ (power to photocells, receivers, etc.)
To safeguard the opener and avoid damaging components while wiring, disconnect the unit from all
power when working on it.
Remember that there are specific, strict standards that must be complied with both as regards the safety
of the electrical systems and as regards automatic doors. Whoever carries out these jobs will be held
responsible for any damage caused by erroneous installation.
NOTE: Contact technical department for the wiring diagram for the above connections if uncertain of the
correct procedure.
Programing the Logic Board
01 - (P button) Programming
02 - (A button) Increase
03 - (D button) Decrease
04 - (C button) Programming Transmitters
--
1 - When you connect the electricity to the Logic Board, the digital screen will display numbers from 99 to
11 in turn. At the same time, the lamp will go off after 2 seconds. When the opener is in standby situation,
LED displays ( )
2 - When the door is opening, LED displays OP.
When the door is closing, LED displays CL.
Note: If an exterior flash lamp is connected, it will flash for caution when the door is moving and the
circular sequence of the control of transmitter or wall switch: open – stop – close – stop.
3 - Functions on the menu
There are 7 functions on the manual as following:
P1: The setting of the upper limit and the bottom limit for door-moving.
P2: The setting of the power (1-9)
P3: The setting of the photocells (On/Off)
P4: The setting of automatic closing of the door (Time from 10 to 90s)
P5: The setting of the condominium function
P6: The setting of the flash caution for the maintenance
P7: The setting of transmitters (Programming at distance)
The choice of the function on the menu is made by pressing A or D key (the operation is not circular and
each time you press a key you move one level up or down on the menu).
When the non-operation on all functions' setting except for function P1 is over 20 seconds, the system
will automatically quit from the setting status.
Pág. 19