REMOCON 60 / 100 Manual Del Usario página 22

P6 - The setting of the flash caution for the maintenance
6.1 - Press and remain the P key 4 seconds and LED displays P1. Access P6 by pressing the A key.
Then press the P key
for 2 seconds and LED displays the current status. C0 means no flash caution. C1 means the flash
caution will appear after the door moves 2000 times. C2 means the flash caution will appear after the
door moves 4000 times. So on and so forth, C9 means the flash caution will appear after the door moves
18000 times. Press P key 2 seconds to set the choice and the system quits from the setting. Finally,
Returns to the stand-by situation (
6.2 - If you want to set a new time, firstly choose C0. Then choose a new level and the count of times will
be restarted.
6.3 - When gets to the set time, the lamp will flash and remain 2 minutes.
P7 - Programming additional transmitters without pressing C key using a transmitter already
programmed
--
7.1 - To enable this function, press and remain the P key till LED displays P1 and access to P7 by
pressing A key. Then press the P key to display the current situation. Press A key to enable (LED
displays L1) or D to disable (LED displays L0).Finally press P key 2 seconds to set the choice and the
system quits from the setting and returns to the stand-by situation (
7.2 - Add new transmitters using existing transmitter to open receiver memory:
Press button 2 and 3 (Fig. 11) at the same time until lamp flash ,when it flashes release buttons and
press any button until motor start working.
Programming transmitters or delete existing ones using C key
Press the C key until digital screen shows SU. Press any key of the transmitter and release the key.
Then repress the key till SU flashes quickly. Once the flash stops, the code-matching is successful.
Repeat this operation every time you want to add more transmitters.
The clearance of the code: press and remain on the C key over 8 seconds to delete all the codes , the
digital screen shows DL.
If the digital screen shows a flash FU means the memory space is full and it can not fill more
transmitters. If you want to input more codes under a full situation, all previous 30 codes have to be
deleted.
Memory Capacity : 30 Transmitters.
The Logic Board is compatible with Rolling Code transmitters.
MAINTENANCE
No particular maintenance is required to the Central.
Verify at least twice a year if the Door is properly balanced and if the moving parts are in good condition.
NOTE: A door that doesn't matches the requirements due to incorrect loads can affect the engine's
lifetime and will void the warranty.
Check at least twice a year the reversing sensitivity and adjust if necessary.
Make sure that the safety devices are working effectively (photocells,etc)
TECHNICAL DATA
Power Input: 230V AC +/- 10% 50Hz
MOTOR: 24V DC
Courtesy light time: 3 minutes
Operation Temperature: >-20ºC, <+70ºC
Relative Humidity: <90%
).
Garage Door Opener 60 / 100
--
).
English
Pág. 21