Final Recommendations; Ce Declaration Of Conformity - Key Automation CT-24M Manual De Instrucciones

GB

FINAL RECOMMENDATIONS

1. Only qualified personnel having the legal requirements must install the automation according to the principles
of good workmanship and in conformity with the machinery directive 98/37/CE and standards EN 12453 and
EN 12445.
2. Check that the existing structures (posts, hinges, leaves) are stable in relation to the forces developed by the
motor.
3. Check that suitably robust limit stops have been installed for end of gate opening and closing.
4. Analyse the hazards connected with the automation system and adopt the necessary safety and signalling
devices accordingly.
5. Install the commands (e.g. the key selector) so that the user is not placed in a hazardous area when using
them.
6. Upon completion of the installation, test the safety, signalling and release devices of the automation system
several times.
7. Apply the CE label or plate with information regarding the hazards and identification data on the automation.
8. Give the end user the instructions for use, the safety recommendations and the CE declaration of conformity.
9. Ensure that the user has understood the correct automatic, manual and emergency operation of the
automation system.
10. Inform the user in writing (e.g. in the instructions for use) of any unprotected residual risks and of foreseeable
misuse.
11. Prepare a maintenance schedule for the automation installation (at least once every 6 months for the safety
devices), recording the work carried out in a special book.
Note! For trouble-free operation and longlife of the gearmotor, periodically grease the lever sliding
points.
DISPOSAL
This product is made up of various components that could contain pollutants. Dispose of
properly!
Make enquiries concerning the recycling or disposal of the product, complying with the local laws
in force.

CE DECLARATION OF CONFORMITY

The undersigned Romeo Bissoli, Director of the company:
KEYAutomation S.r.l. Via Alessandro Volta, 30 - 30020 Noventa di Piave (VE) ITALY
declares that the product:
Model CT-24M for use as: Gate automation control unit
Model: CABAT-30 for use as: Battery charger
complies with the essential requirements of section 3 and relative measures of Directive 1999/5/CE, if used for
the purpose for which it has been designed.
complies with the essential requirements of Directive 89/336 (EMC), EN 61000-6-3, EN 61000-6-1 and
subsequent amendments, if used for the purpose for which it has been designed.
complies with the essential requirements of Directive 73/23 (LVD), EN 60335-1 and subsequent amendments, if
used for the purpose for which it has been designed.
Place and date: Noventa di Piave (VE), 10/07/2005
Director
Romeo Bissoli
39