Publicidad
GENERAL SAFETY INFORMATION
When using electrical appliances, basic precautions should always be followed to reduce
the risk of fire, electrical shock and injury to persons, including the following:
Read all instructions before using this Fan.
DO NOT DEPEND ON THE ON/OFF SWITCH AS THE SOLE MEANS OF DISCONNECTING POWER WHEN MOVING
THE FAN. ALWAYS UNPLUG THE POWER CORD. ALWAYS TURN OFF AND UNPLUG FAN BEFORE LEAVING THE
AREA. NEVER LEAVE CHILDREN UNATTENDED WHEN THE FAN IS ON OR PLUGGED IN. DO NOT UNPLUG FAN
FROM OUTLET DURING INCLEMENT WEATHER.
The power cord is equipped with a three-prong, grounded GFCI (Ground Fault Circuit Interrupter) plug that must be
inserted into a grounded receptacle. Under no circumstances must the grounding prong be cut off the plug. Where a
two-prong wall receptacle is encountered, it must be replaced with a properly grounded three-prong receptacle installed
in accordance with the National Electrical Code (NEC) and all applicable local codes and ordinances. This work must
be done only by a qualified electrician, using copper wire only. The GFCI Fan cord set can be plugged into an existing
GFCI outlet if present.
RISK OF ELECTRIC SHOCK. TEST GFCI PLUG BEFORE EACH USE.
1. PLUG GFCI INTO POWER OUTLET. INDICATOR LIGHT SHOULD TURN ON.
2. PRESS TEST BUTTON. INDICATOR LIGHT SHOULD TURN OFF.
3. PRESS AND RELEASE RESET BUTTON. INDICATOR LIGHT SHOULD TURN ON.
If above test fails, DO NOT USE THIS GFCI. Call 800-233-0268, Mon - Fri, 8:00 a.m. and 5:00 p.m. EST.
USE OF A THREE-PRONG TO TWO-PRONG ADAPTER IS NOT PERMITTED. IMPROPER CONNECTION MAY CREATE THE
RISK OF ELECTROCUTION. USE OF SUCH ADAPTERS IS NOT PERMITTED IN CANADA.
This plug is a safety feature to reduce the risk of fire, electric shock and personal injury. DO NOT remove, replace,
repair or tamper with the originally supplied plug or GFCI. If the Fan does not function properly, it may be due to
the safety device incorporated in this plug. Call 800-233-0268, Monday - Friday, between 8:00 a.m. and 5:00 p.m.
EST. If the plug warning label is missing or damaged, call the toll free number for a replacement label.
1.
Make certain the power source conforms to the electrical requirements of the Fan.
2.
Make certain that the room is equipped with a working smoke detector if using this Fan indoors.
3.
Use this Fan only as described in this manual. Any other use not recommended by the manufacturer may cause fire, electrical shock, or
injury to persons.
4.
To reduce the risk of personal injury and electric shock, the Fan should not be played with or placed where small children can reach it or climb on it.
5.
Unplug power cord before moving the Fan - DO NOT attempt to unplug or move the Fan during inclement weather.
6.
This Fan must NOT be used in potentially dangerous locations such as flammable, explosive or chemical-laden atmospheres where gasoline, paint
or flammable liquids are used or stored.
7.
DO NOT use extension cords because the extension cord may overheat and cause a fire.
8.
NEVER operate any Fan with a damaged cord or plug or after the Fan malfunctions, has been dropped or damaged in any manner. There
are no user serviceable parts. This GFCI plug does not protect against electrical shock due to contact with both circuit conductors or a
fault in any wiring supplying this device. Do not use an extension cord between the Fan GFCI cord and power outlet. Customer service
is available at 800-233-0268, Monday through Friday, 8am to 5pm to answer your questions.
9.
NEVER insert or allow fingers or foreign objects to enter any ventilation or exhaust opening as it may cause an electric shock or fire, or damage
the Fan. To reduce the risk of fire, DO NOT block or tamper with the Fan in any manner while it is in operation.
10. Always place the Fan on a stable, flat, level surface when operating to avoid the chance of the Fan overturning. Locate the Power Cord so the Fan
or other objects are not resting on it. DO NOT run Power Cord under carpeting. DO NOT cover Power Cord with throw rugs, runners or the like.
Arrange Power Cord away from area traffic and where it will not be tripped over.
11. Never locate a Fan where it may fall into a pool, hot tub or other water container. NEVER use Fan where flammable liquids are used or stored.
12. DO NOT use this Fan in close proximity to cooking grills, fire pits or other open flames.
13. For outdoor stability, this Fan is weighted. Please use caution when moving or lifting.
14. Remote controls for other appliances or electronic equipment can sometimes interfere with the operation of this Fan. If this occurs, move the Fan
to another location.
15. Keep Fan remote control unit away from chairs and your bed where it may be sat or laid upon and inadvertently turn on the Fan.
16. This Fan is not suitable for use in agricultural facilities including areas where livestock, poultry or other animals are confined. Please refer to Na-
tional Electric Code (NEC) Article 547-7 (2002), or applicable state or local codes or standards relating to electrical requirements for Agricultural
Buildings. THIS FAN DOES NOT MEET THE REQUIRMENTS OF NEC ARTICLE 547-7 (2002).
17. This Fan is not suitable for use in hazardous locations. Please refer to National Electric Code (NEC) Article 500 or applicable state or local codes
or standards relating to electrical requirements for Hazardous locations. THIS FAN DOES NOT MEET THE REQUIRMENTS OF NEC ARTICLES
500 (2002)
REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK - DO NOT USE THIS FAN WITH ANY
SOLID STATE SPEED CONTROL DEVICES.
SAVE THESE INSTRUCTIONS
Rev. A 6/07
2
Control de Rejilla
(Figura 6)
Además de la función de oscilación, este ventilador posee rejillas en la parrilla frontal que permiten el ajuste vertical del flujo de aire. Mueva
el Control de la Rejilla (Inserto 6A) hacia arriba o hacia abajo para ajustar el flujo aire según lo desee.
Función de apagado automático:
Este ventilador está equipado con una función de apagado automático. Si el panel de control no es tocado durante 14 horas continuas, el
ventilador se apagará. Oprima el botón de encendido/velocidad para retomar el uso. Esta función NO afecta la iluminación específica.
Para desactivar la función de apagado automático, oprima y mantenga oprimido el botón de oscilación hasta que oiga 4'bips'.
Para activar la función de apagado automático, desconecte la unidad durante 30 segundos, conecte el cable eléctrico en el tomacorriente, siga
las instrucciones para la prueba del enchufe del interruptor de circuito sin conexión a tierra (GFCI) y continúe con el uso normal.
Trasladando su ventilador armado:
Si es necesario trasladar el ventilador después de su armado, desconecte el ventilador y cuidadosamente levántelo por la sección central del ventilador
y colóquelo en su nueva ubicación. NO incline el ventilador tomándolo de la cubierta o de la base del mismo. NO ARRASTRE EL VENTILADOR.
NOTA:
Para su estabilidad al aire libre, este ventilador posee contrapesos. POR FAVOR TENGA CUIDADO AL TRASLADARLO O
Control Remoto
(Figura 7)
Herramientas Requeridas: Destornillador de Cabezal Phillips N° 2 (no incluido)
1. Instale la batería CR2025 provista y luego ajuste los tornillos de (4) M3 X 8 mm también provistos. (Figura 7)
2. Todas las funciones ejecutadas por el control remoto trabajan idénticamente a las de los controles manuales.
3. Ocasionalmente limpie la lente del panel de control y la lente del control remoto con un trapo seco.
4. NO DESECHE LA BATERIA EN EL FUEGO. LA BATERIA PUEDE EXPLOTAR O SUFRIR FILTRACIONES.
Figura 7
Si usted pierde su mando a distancia, por favor Cliente de llamada Serive para ordenar un reaplacement en 1-800 -233-0268, de lunes a
viernes, entre las 8 a.m. y las 5 p.m. (Horario Estándar del Este de los Estados Unidos).
MANTENIMIENTO
Para reducir el riesgo de choque eléctrico e incendio, por favor siga las siguientes instrucciones:
- Siempre desconecte el cable eléctrico antes de trasladarlo o limpiarlo.
- NUNCA intente desarma el ventilador.
- Limpie el cuerpo del ventilador con un trapo suave humedecido con agua y detergente suave únicamente.
- NO use ningún tipo de manguera de jardín y/o equipamiento de lavado a presión para limpiar este ventilador. Este
ventilador no está diseñado para soportar una corriente de agua concentrada a alta presión.
- NUNCA use ALCOHOL o SOLVENTES tales como gasolina, bencina, adelgazador para pintura u otros limpiadores duros para
limpiar este ventilador.
2085461
Rev. A 6/07
MODELO 4890
Inserto 6A
Figura 6
11
2085461
Publicidad
