Care And Maintenance - Klarfit Runtasy SE Manual De Instrucciones

EN
48

CARE AND MAINTENANCE

Lubrication
Running a period of time , must be configured with special cymene silicone oil
for lubrication. Suggestion:
• Using less than 3 hour each week: 5 month lubrication
• Using 4~7 hours each week: 2 month lubrication
• Using up to 7 hours each week: 1 month lubrication
How to Lubricant
1 Stop running belt so that the seam is located on top and in the center of
the desk.
2 Insert nozzle into spray head of lubricant can.
3 Lift running belt
4 Position nozzle between the belt and the board approximately 200 mm
(8") from the front of the treadmill.
5 Apply the silicone from the front to the rear for the treadmill on each side
of the treadmill. Try to reach the spray as far into the center of the running
desk as possible .The spray time should be approximately four seconds for
each side .
6 Spread the silicone by running the treadmill at 0.8 km/h and step gently on
the belt front the left to right.
Running Belt Tension Adjustment
The treadmill has been adjusted and passed QC inspection before leaving the
factory. If there is phenomenon of bias running of the belt, the possible reasons
might be:
• The frame is not stably laid.
• The user is not running on the centre of the running belt.
• The user's two feet are not using even strength.