Zodiac Security ZS-10A Manual De Instrucciones página 20

Setup mode
To enter Setup mode, switch to Normal mode and then enter [your admin code +
#] on the keypad. The LED indicator blinks once every second. Press [*] to exit the
Setup mode and switch to the Normal mode.
After 30 seconds without operation, the keypad goes back to the Normal mode.
Default Admin code: 123456
Note:
Correct operation: 1 beep and the LED light blinks once
Wrong operation: 2 beeps and the LED light blinks twice
Register the ZS-10A in the control panel
Make sure the control panel is in Connection mode (refer to the user manual of
your alarm system).
Press Arm [ ] or Home Mode [ ] on
the keypad to unlock it.
Type your user code or admin code on
the keypad, and than press any of the
Arm [ ], Disarm [ ] or Home Mode
[ ]. You hear short beeps: the
registration has succeded.
Default Admin code: 123456. Default user code: 1234
The control panel of your alarm system cn be controlled from distance on the
keypad once the latter has been registered in the control panel.
Connect the ZS-10A to a Zodiac siren
The ZS-10A can be connected to a Zodiac indoor or outdoor siren, which enables
you to trigger the siren by pressing the [SOS] key on your keypad.
To connect the keypad to a Zodiac siren, set the wireless siren to Connection Mode
(refer to the manual of your Zodiac siren if necessary). Press Arm [ ] or Home
Mode [ ] key on the keypad to switch to normal Mode. Then type [your admin
code or user code] and press any of the Arm [ ], Disarm [ ] or Home Mode [ ]
keys on the keypad.