Dyna-Glo DGE530BSP-D Manual De Instrucciones página 9

asseMBLY insTruCTiOns
5. Insert 2 screws (DD) into left edge of upper front
door brace (Y), but do not tighten. Leave 4-6mm
clearance from screw head to the bottom of upper
front door brace (Y). Attached left support for upper
front door brace (U) onto the inserted screws.
Secure with 2 additional screws (DD) and tighten all
four screws (DD). Repeat with right support for
upper front door brace (V).
Hardware Used
M4x12 Screw
DD
6. Remove preassembled 2 screws (AA) and
door handle sleeve (N) from the door handle
(L). Insert the 2 door sleeves (N) into the holes
located on the back of the door assembly (J),
Insert 2 screws (AA) into the door handle
sleeve (N), through the door handle bezels
(M) and into the thread holes in the door
handles (L). Tighten the screws. As shown on
below figure. Repeat with right door
assembly (K).
Hardware Used
M6x12 Screw
AA
5
Y
x 8
DD
6
L
x 4
9
V
U
DD
Y
J
M
U
H
N
AA